Lubricants for automotive and company fleets

Viscosity grades, performance specifications and manufacturer approvals: how to find your way among engine oils, transmission fluids and new products for electric mobility.

  • Viscosity and specificationstwo separate pieces of information
  • Transmissionsdedicated oils and fluids
  • Electric vehiclesfluids with electrical and thermal requirements

Vehicle lubricants: a world of specifications

In the automotive sector, the choice of lubricant is driven above all by the vehicle manufacturer's instructions. For workshops, dealerships and company fleet managers, knowing how to read grades and specifications is essential to use the right product and preserve the warranty and reliability of the vehicles.

A vehicle contains several fluids: engine oil, gearbox and differential lubricants, greases for bearings and joints, plus fluids that are not strictly lubricants but need the same attention, such as brake fluid and coolant. With the spread of electric and hybrid vehicles, fluids designed for electric drivetrains and thermal management have also appeared.

Engine oil being poured during engine maintenance, lubricants for automotive and company fleets
Topping up with the wrong product can damage the engine and the exhaust after-treatment systems.

Engine oil: viscosity and specifications

The packaging of an engine oil carries two different pieces of information, and both must be read. The first is the viscosity grade: in multigrade oils it consists of two numbers, the first followed by the letter W, which describes cold behaviour, and the second, which refers to viscosity at engine operating temperature. A lower number before the W indicates an oil that flows better at cold start.

The second piece of information concerns performance specifications and manufacturer approvals. Two oils with the same grade can have very different formulations: specifications set requirements for wear protection, engine cleanliness, stability and compatibility with exhaust treatment systems. Many modern engines with particulate filters require oils with low sulphated ash, phosphorus and sulphur content, so as not to damage the after-treatment devices.

Viscosity is not enough

Choosing an oil on the basis of its grade alone is a common mistake. The product must also meet the specification or approval required by the manufacturer for that engine, as stated in the owner's and maintenance manual.

Transmissions, differentials and greases

  • Manual gearboxes They use gear oils with properties suited to the synchronisers, according to the manufacturer's instructions.
  • Automatic transmissions There are different fluids for conventional automatic, continuously variable and dual-clutch transmissions: they are not interchangeable.
  • Differentials The bevel gear sets work with high sliding and require oils with extreme pressure additives; some limited-slip differentials have specific friction requirements.
  • Greases Constant velocity joints, bearings and linkages use dedicated greases, often already filled at the factory into sealed components.

Electric and hybrid vehicles

Electric vehicles do not have a conventional engine oil, but they still need lubricants for their reduction gearboxes and, in many designs, fluids that lubricate the gears and cool the electric motor at the same time. These fluids must have suitable electrical properties, be compatible with copper, insulation and electronic components, and handle heat well. Electric motor bearing greases are also chosen with high speeds and possible stray currents in mind. In hybrid vehicles the combustion engine often runs in short cycles with frequent starts, conditions that the recommended oils take into account.

Management for workshops and fleets

  • Up-to-date data Always check the manufacturer's requirements for each model and engine.
  • A well-planned range A few carefully chosen products cover most of the vehicles being managed.
  • Recording interventions Product, quantity and mileage at each change document the maintenance history.
  • Separate collection Used oils, filters and containers must be handed over to authorised operators.

Workshop safety

Used oil and raised vehicles

Used engine oil contains combustion residues: avoid prolonged skin contact by wearing suitable gloves, wash your hands after work and do not use solvents to clean them. Oil drained from a hot engine can cause burns. Before working under a raised vehicle, check that it is stable on the lift or on the proper stands, never on the jack alone.